All Products
Distortion
My First Distortion (Electra Distortion clone)My First Distortion (Electra Distortion clone)
Fuzz
My First FuzzMy First Fuzz is a classic DIY project for anyone who has always wanted to build their own guitar pedal. It's a beginner-friendly kit, and it gives you a big sounding fuzz without a complicated build. The circuit board is compact and has a low parts count, so the assembly stays straightforward. It's a good first soldering job if you're new to pedal building. Compact PCB that fits neatly into most pedalboard setups Incorporated 3PDT switch for true bypass switching Connection for an optional LED indicator so you can see at a glance when the pedal is on Low parts count for easy, beginner friendly assembly Handy tip: check the pin out of the BJT transistor before you start assembly. Getting that right first will save you a lot of head-scratching later. Whether you're after your very first pedal or just want something fun to build on a rainy afternoon, My First Fuzz is a satisfying project with a proper fuzz sound at the end of it.
Utility
Perfect MatchThis one is for the effects pedal DIY'ers. This will test the VG off of a jfet to get that "Perfect Match" for such circuits as a Phase 45 or Phase 90 phaser. Low parts count and easy to assemble with 9v power connections via a battery or negative centre 9v power supply How to use: Find the correct pin out of your jfet and place the pins in the corresponding sockets on the pcb ( G=Gate, S=Source, D+Drain) Connect you digital multi meter probes to the connectors on the board (Black probe to DMM - and red probe to DMM+). Set multi meter to VDC, connect power supply or battery and take the reading.
Bass FX
Sunn 200s bass pre ampThe Sunn 200S Preamp is a compact, JFET-based stompbox adaptation of the legendary late-1960s Sunn 200S tube bass amplifier. Engineered to translate the massive low-end headroom, punchy clarity, and warm harmonic grit of the vintage 6550/KT88-driven head onto a pedalboard, it substitutes the original amp's high-voltage tubes with a pair of biased JFETs. Key Circuit & Tone Features Amp-in-a-Box Architecture: Similar in spirit to a Fender Bassman preamp, the 200S places its passive tone stack at the end of the circuit rather than in the middle. This layout preserves raw, uncompressed signal punch while letting you sculpt the final output. Expanded Tone Shaping: While the vintage 1967 Sunn 200S amp only featured Bass and Treble controls (alongside Hi/Lo boost switches), this DIY layout adds a dedicated Mid control. Combined with a Master Volume, it gives bassists and baritone/downtuned guitarists far greater control over how their signal cuts through a dense mix. Pedalboard-Friendly Fo...
Distortion
That 70's DistortionFancy a bit of proper 70s grit? That 70's Distortion is our take on the classic Distortion Plus, the sound a lot of players reach for when they want a dirty, punchy tone without overthinking it. If you've ever loved the original MXR Distortion Plus, this one's worth a look. It's aimed at anyone who likes their distortion with a bit of character, whether you're chasing vintage crunch for rock riffs, blues leads or just messing about at home. It's a straightforward sound that sits nicely on a board or works well on its own. Here's what you can expect: Our own take on the classic Distortion Plus tone Gritty, retro-flavoured distortion with plenty of bite Simple to use, so you can get straight to playing Plug in, turn it up and see what it does to your sound. Classic vibe, our twist.